Wire stripping machine waste copper recycling equipment

The wire stripping machine has a wide range of applications and a long service life. It can open and loosen all kinds of cables, high-voltage cables, optical cables, electric wires, etc. The roller can compress monofilaments, sheathed flat wires, steel wires, etc. above 1.5mm.

Wire stripping machine operation instructions:

1 Start the cable stripping machine motor and check whether it is running normally. When feeding, check the outer diameter of each gear of rubber and plastic cable and feed the material one by one.

2 In order to make the cable stripping machine blade durable, the joints of the rubber and plastic cable should be cut off when feeding to avoid the blade notch from cracking. 3. If the material is found to be too deep or broken after feeding, the following points should be noted: the feeding gear should be adjusted, that is, the tightness of the M12 screw pressure on both sides of the blade shaft; check whether the position is misaligned during feeding; whether the blade is newly replaced, whether the edge is too sharp, and use a special oilstone to slightly trim it to a moderate level.

4. If the rubber and plastic have been peeled off after feeding, but the copper wire cannot be spit out, there are mainly 4 situations: the upper shaft knurling is too deep, and the upper shaft should be ground with a special oil stone, but it should not be ground too deep. Grinding too deep can easily cause difficulty in driving the oil-containing cable; the spring pressure is too loose, and the pressure should be tightened to stop spitting out the wire; the wire diameter is too small, or the gap between the upper and lower shafts is too large, and the gap between the two shafts should be adjusted to 0.4-0.6mm; the processed rubber and plastic cable has heated up and cannot spit out the copper wire.

5. After the cable stripping machine feeds, if the composite pressure wheel cannot drive the cable over, and the material stays in the middle, the following situations will occur: Check whether the belts of each gear are loose; Check whether the spring pressure on both sides of the pressure wheel is too large. If there is no top force, the pressure should be relaxed; the cable is too oily, causing the two shafts to slip, and the two shafts should be wiped dry frequently (when wiping, if the machine is running, please pay attention to safety)

Common problems of wire stripping machines: the outer skin has been peeled after feeding, but the copper wire still cannot be exposed. There are mainly the following situations:

1. The knurling of the upper shaft is too deep. Use a grindstone to grind the upper shaft, but don't overdo it. Excessive grinding can easily make oily cables difficult to drive;

2. Is the spring pressure too loose? The pressure should be tightened:

3. The wire diameter is too small, or the gap between the upper and lower shafts is too large. Adjust the gap between the two shafts appropriately;

4. The processed cable has been heated, and the copper wire will not easily expose the outer skin.

5. After the cable stripping machine feeds, the rolling gear cannot drive the cable, and the material is stuck in the middle. The following situations will occur:

1) Check whether the belts of each gear are loose;

2) Check whether the spring pressure on both sides of each gear is too tight and there is no top force. The pressure should be relaxed; 3. The cable is too oily, causing the two shafts to slip. The two shafts should be cleaned frequently.

If you have any requirements or suggestions, you can contact us at any time!